Page 3 of 16
2015-2020 CHEVY TAHOE / 2014-2019 CHEVY SILVERADO
The Running Board lights for the 2015-2020 Chevy Tahoe / 2014-2019 Chevy Silverado fit under the vehicle’s running board and provide a
lateral facing signal from the side of the vehicle.
Step 1.
Remove three (3) 13mm bolts and one (1) 10mm bolt from under the rocker panel. (See Figure 1 & 2)
Step 2.
Loosen, without removing, three (3) 13mm bolts (See Figure 3). Allowing the rocker panel assembly to lower ~1/4” (See Figure 4).
Step 3.
Using the provided screws, mount the provided brackets to the unit where shown in Figure 5.
Note: Bracket is slotted in order to use existing holes on the unit.
Step 4.
Slide the unit into position while guiding brackets to approximate locations (See Figure 6).
Step 5.
Align brackets to existing mounting holes and fasten using three (3) 13mm bolts removed in Step 1.
Step 6.
Fasten remaining bolts removed in Step 1 and tighted bolts loosened in Step 2.
Step 7.
Repeat the process for the opposite side running board.
Step 8.
Route the lights wiring as desired.
Note: Instructions are made using Driver’s Side as example. To Reproduce results, revisit each step for Passenger Side.
Installtion and Mounting Instructions:
