5
0
2
0
1
0
2
0
2
0
3
0
3.
How to DELETE all pin codes of all the users
Enter
0 0 0
followed by the star ( * ) key then press and hold the hash key ( # ) for three seconds, till you
hear the announcement : “
Deleted
“
4.
How to change the installer’s pin code
The factory default of the installer’s pin code is
9 9 9 9
In Program Mode, you can change the installer’s pin code for security reasons, as follows:
Press: * 0 0 0 * Enter the new four digit installer’s pin code and then #
5.
How to Exit Program Mode.
The system will exit program mode automatically if no command was received within 1 minute, or by
the following command:
Press
* => 0 => #
you will hear a long beep and the unit will exit Program Mode and
hang up if the programming was made by dialing in.
(C ) choosing and setting Functions in Program Mode
6.
How to set the Pulse
T
ime of the relay
The factory default setting of the relay’s function is
MOMENTARY
pulse of
3
seconds.
The pulse time of the relay can be set from ½ second to 10 seconds as follows:
Enter: * 0 0 1 * 0 # => for ½ second pulse time.
Enter: * 0 0 1 * 1 # => for 1 second pulse time.
Enter: * 0 0 1 * 2 # => for 2 second pulse time.
Enter the
T
ime required here
Enter: * 0 0 1 * 8 # => for
10
second pulse time.
Enter: * 0 0 1 * 9 # => for
15
second pulse time.
The system will confirm
the set time
by a
Beep sound
as long as the chosen
T
ime.
i.e., if the time was set for 7 seconds then the buzzer will “Beep” for 7 seconds.
7.
How to choose the relay’s function
The factory default function of the relay is
MOMENTARY (
pulse 3Sec
.).
There are two functions to choose from:
Momentary
or
Latch
function.
For
Latch
function: then you will hear one beep to confirm.
For
Momentary
function: then you will hear two beeps to confirm.
8.
How to set the system to the factory default settings
The system can be set to the factory’s default settings as follows:
You will hear one long Beep and then the installer must repeat the same command again to
confirm within 10 seconds; otherwise, the system will disregard this command.
