3
10 Mountain View Drive • Shelton, CT 06484 • P:800.521.3175 • F:203.924.6687 • www.electri-cable.com
©
ECA– April 2014—Product specifications subject to change without notice
INSTALL-MARHD-041014
Innovative Power + Data Solutions
9065-0256 Rev C
Surface Preparation:
1. Provide a cutout in surface for the Marina HDMI at desired location as shown in Fig. 1. (Note Fig. 1 repre-
sents underside of work surface)
2. Mark or pilot drill the location for center mounting screws as shown in Fig. 1. Note: Use caution that any
pilot holes do not pierce finished surface.
Marina HDMI Grommet Installation:
1. Adjust Grommet for table thicknesses less than 1.18” (30mm) by removing Grommet Skirt. For table thick-
nesses greater than 1.18” (30mm) proceed to step 2 below.
a. Remove 4 bottom Grommet screws in each corner of Grommet. Retain screws for reinsertion into
Grommet later. Note: Do not remove or loosen top Grommet screws.
b. Remove and discard skirt.
c. Reinstall the 4 screws removed above.
2. Insert Grommet into surface cutout and secure to table with 2 - #8 flat head screws (not provided) through
mounting holes in side of Grommet, see Fig. 2. Ensure Grommet is centered in cutout and flat to work sur-
face.
3. Check for smooth operation of both doors.
Marina HDMI Technology Bay Installation:
1. Install 1 - #10 pan head screw (not provided) into center mounting screw position on underside of work
surface, see Fig.1. Do not fully tighten screw at this point. Note: Ensure all screws will not pierce finished
work surface.
2. Insert middle flange slot of one end of the Marina onto mounting screw to support the Marina while in-
stalling 2nd - #10 pan head screw (not provided) align with the other center mounting screw position. Do
not fully tighten screws at this point.
3. Center the Marina in the cutout and secure to underside of surface using remaining holes in side flanges.
Note: It is important that the Marina is centered in cutout and there is a consistent air gap between the
Marina and Grommet.
4. Tighten center screws from step 1 and 2 above.
Making Connections:
1. Connect HDMI cable provided between Marina HDMI output port, see Fig. 3, and screen HDMI input port.
2. Connect power cord to 120 VAC outlet.
Operation:
1. To verify that the switcher is operating as designed, connect two or more inputs devices (laptops or tab-
lets) to the user HDMI “Share” cords and switch the display between the units. If no image is displayed on
your monitor, confirm the monitor’s input setting is correct. Confirm the monitor to Marina output connec-
tions are secure. Visual Note: check the display window on the side of the unit. In the center INPUTS win-
dow there should be one LED lit. In the right window for signals, there should be the LED for the output lit
and one inputs signal LED lit for each device connected to the share cables, Fig. 4.
Marina HDMI
™
Install Instructions
