2
4. Antenna
M
ake sure to install the GSM antenna as high as possible and do not fold the excessive wire of the
antenna.
5. Power
The unit can operate with voltage between 12V to 24V AC or DC by the Orange and Yellow wires of
the unit. If DC power is used, the
yellow
wire is the
Negative
and the
Orange
wire is the
Positive
.
Wait 25 seconds
for the unit to set up after connecting the power. The GSM and Status LEDs will
start to flash when the system is ready.
6. Memory
The unit can be programmed with
1000 phone numbers
to become as
authorized users
. The system
will respond or answer (according to the settings – see below) to the call of authorized users only and
hang-up on unauthorized calls.
7. Output
The Grey and Purple wires of the unit are the internal relay’s output connections COM & N.O. that
can be used to activate any gate, garage door or alarm. Use the Grey (Com.) and the Purple (N.O.)
wires in the unit to trigger the control panel of the appliance.
8. Relay’s Function
You can select one out to two functions for the internal relay to activate the external control panel by:
Dip – Switch # 3
:
OFF =>
Pulse function
or
ON =>
Latch function
9. PROGRAMM MODE
In Program Mode you can:
•
Add or delete users’ phone numbers.
•
Lock and Unlock the system by the MASTER number.
Entering PROGRAM MODE:
1. Set
DIP-SWITCH
# 1
to
ON
position to enable entering Program Mode.
2. Dial the unit’s Sim Card phone number from any phone.
After the first ring, the unit will answer the call with a long “Beep” sound and wait for your
programming instructions.
3. First you need to
clear
the memory of the Sim card from any data and phone numbers.
For
DELETING
all the phone numbers in the unit’s memory
except the MASTER phone
number;
Press
* + 4 + * + * + * + #
=>
a long beep to confirm
.
4.
Master Phone Number
Program-in the
M
aster
P
hone
N
umber (
MPN
) that will enable you to make all the programming
features (from this phone number only) without the need of accessing the unit in the future.
Please Note!
The
MPN
can enter Program Mode without setting Dipswitch #1 on in the unit. The unit will
always answer the Master phone number and automatically enter programming mode,
even if the
Dip Switch No. 1 is OFF
.
For programming the
MASTER
Phone Number
:
Press
000 + * + phone #
=> a long beep to confirm.
The unit will announce the phone number after programming to confirm.
