Editing presets on the SuperSwitcher is very easy and can be done in a few seconds, the instructions
are very easy:
1 -
With the BANK button - set the bank you want to edit it’s presets.
2 -
Press the EDIT button for 2 sec’ you will see the blue LED flicks for a second and then it turned off - release press.
3
- If you want to edit a manual switch instead of preset press the bank button once at this point (C LED will flash)
4 -
Now press for 2 sec on the preset you want to edit 1-7
5 -
You are now editing a specific preset on a specific bank - on this mode the BANK LED’s represent L mode for loops
or S mode for switchers. You can switch between the 2 modes with the BANK button.
6 -
Set BANK button to L mode and press buttons 1-8 (8 is the EDIT button) to choose which loops you want to activate
on this specific preset that we are editing.
7 -
Set BANK button to S mode and press buttons 1-5 to choose which relay switches you want to activate on this specific
preset that we are editing.
8 -
When finished you can either save the preset and start editing another preset by pressing the SAVE(Tuner\Mute)
button once , or when you finished editing all the presets you want and go directly to “PLAY” mode press it for 2 sec’.
Those are the steps for editing a preset, you can do this in order to edit all 1-7 presets within all 3 banks.
Reset mode -
if you want to reset the superswitcher from all presets (factory reset) - unplug the DC cable from the super
switcher, while the unit is off press both the BANK and BYPASS\EDIT buttons together and keep them pressed, while you
are still pressing them plug back the DC cable to the unit - LED’s will flash and tell you the factory reset is done.
Manual mode -
if you dont want to use your presets at all at certain day you can set the superswitcher to act as a
normal pedal board with up to 8 pedals and 1 relay switch, to do so unplug the DC cable from the super
switcher, while the unit is off press both the TUNER\MUTE and BYPASS\EDIT buttons together and keep them pressed, while you
are still pressing them plug back the DC cable to the unit - LED’s will flash and tell you the you are in manual mode.
In this mode you can press 1-8 buttons to immediately turn on loops 1-8, you can turn on and off couple of loops together,
also you can use the BANK button in this mode to turn on S1 relay switch. keep in mind the buffer and the TUNER options
can be used in manual mode.
Link connections -
you can use 2 superswitchers and link them together for multiple modes:
1 - Put one backstage with all the pedals and amps and one of the stage front just as a controller to get clean stage operation
2 - Put one on the stage for your in front pedals and one back stage for your FX LOOP pedals
3 - Just to add more loops and controls
Before you plug both units you need to edit your presets:
1 - Edit your preset on the first superswitcher with the loops and switches you want to for this unit
2 - Edit the same preset on the second superswitcher with the loops and switches you want to for this unit
3 - when the cable is connect and you press on “play” mode on the preset you will see it sets your preset on both units
