Chengdu Ebyte Electronic Technology Co,;Ltd E70-915T14S user manual
Copyright ©2012–2019
，
Chengdu Ebyte Electronic Technology Co,;Ltd 15
Configuration
Parameter configuration can be made in configuration mode with specific instruction format and UART 9600,
8N1.
Note
When entering other modes from configuration mode, the module will reconfigure parameters, AUX keeps low
level during configuration;
After configuration completed, it outputs high level, so users are recommended to check the AUX rising edge.
6.8 Power Saving Mode (Mode 6)
Status
M0=0 M1=1 M2=1
Transmitting
Transmission is not available.
Receiving
Receiving is available.
Baud rate & air
data rate
Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have different
baud rate but same air data rate.
Advantage
The module works under WOR status, it wakes up periodically and monitors the wireless data packets, when data
packet monitored, the module enters receiving mode and receives complete data packets, and outputs the data
through serial port, and then enters WOR status again, which can save power consumption significantly.
Disadvantage
Transmission is not available under this mode, the module must be switched to other mode for data transmission.
Applications
Applicable for those devices which have requirement on power consumption and need to receive data.
Note
It can only receive the data sent from the transmitter under mode 4.
6.9 Sleep Mode (Mode 7)
Status
M0=1 M1=1 M2=1
Transmitting
Transmitting is not available.
Receiving
Receiving is not available.
Others
Other functions of the module are closed, only can quit sleep mode by switching the M0, M1 and M2 status.
7.Instruction Format
In configuration mode
（
Mode 3
：
M0=1, M1=1, M2=0
）
, it supports instructions below.
(
Only support 9600 and 8N1 format when setting
)
