Ebyte E28-2G4T27SX, Руководство пользователя

Страница: 15 / 20

Chengdu Ebyte Electronic Technology Co.,Ltd. E28-2G4T27SX User Manual
Copyright ©2012–2020, Chengdu Ebyte Electronic Technology Co., Ltd.
14
8.
Hardware design

It is recommended to use a DC stabilized power supply. The power supply ripple factor is as small as possible,

and the module needs to be reliably grounded. ；

Please pay attention to the correct connection of the positive and negative poles of the power supply.

Reverse connection may cause permanent damage to the module ；

Please check the power supply to ensure it is within the recommended voltage otherwise when it exceeds the

maximum value the module will be permanently damaged ；

Please check the stability of the power supply, the voltage can not be fluctuated frequently ；

When designing the power supply circuit for the module, it is often recommended to reserve more than 30%

of the margin, so the whole machine is beneficial for long-term stable operation ；

The module should be as far away as possible from the power supply, transformers, high-frequency wiring

and other parts with large electromagnetic interference ；

High-frequency digital routing, high-frequency analog routing, and power routing must be avoided under

the module. If it is necessary to pass through the module, assume that the module is soldered to the Top

Layer, and the copper is spread on the Top Layer of the module contact part(well grounded), it must be close

to the digital part of the module and routed in the Bottom Layer ；

Assuming the module is soldered or placed over the Top Layer, it is wrong to randomly route over the

Bottom Layer or other layers, which will affect the module's spurs and receiving sensitivity to varying

degrees ；

It is assumed that there are devices with large electromagnetic interference around the module that will

greatly affect the performance. It is recommended to keep them away from the module according to the

strength of the interference. If necessary, appropriate isolation and shielding can be done ；

Assume that there are traces with large electromagnetic interference (high-frequency digital, high-frequency

analog, power traces) around the module that will greatly affect the performance of the module. It is

recommended to stay away from the module according to the strength of the interference.If necessary,

appropriate isolation and shielding can be done.

If the communication line uses a 5V level, a 1k-5.1k resistor must be connected in series (not recommended,

there is still a risk of damage) ；

Try to stay away from some physical layers such as TTL protocol at 2.4GHz , for example: USB3.0 ；

The mounting structure of antenna has a great influence on the performance of the module. It is necessary to

ensure that the antenna is exposed, preferably vertically upward. When the module is mounted inside the

case, use a good antenna extension cable to extend the antenna to the outside
；

The antenna must not be installed inside the metal case, which will cause the transmission distance to be

greatly weakened.