Copyright ©2012–2021
，成都亿佰特电子科技有限公司
9
replace it with the same type of function Go_xxxxx().
2 Sending mode
When calling the sending function, the underlying driver actually
switches the module into standby mode first, and usually completes the
modulation parameter configuration in this mode, such as frequency,
power, frequency offset, etc. After the parameters are configured
correctly, gradually enter some intermediate modes, open the internal
FIFO, PA, external XTAL, etc., and the current consumption will
gradually increase. Eventually switch into send mode, triggering
wireless data transmission. After completion, the module enters the
standby mode. In this state, sending and receiving cannot continue, and
the user needs to handle the next step in the callback function. When the
function is complex, if continuous reception or continuous transmission
is required, please further switch to other modes according to the
characteristics of the chip.
The timing diagram is as follows: