Ebyte 4463, Руководство пользователя

Страница: 8 / 11

Chengdu Ebyte Electronic Technology Co.,Ltd E30-400M30S
（
4463
）
User
Manual
Copyright ©2012–2021，Chengdu Ebyte Electronic Technology Co.,Ltd.
8
the module. If it is necessary to pass through the module, assume that the module is soldered to the Top Layer, and
the copper is spread on the Top Layer of the module contact part(well grounded), it must be close to the digital part
of the module and routed in the Bottom Layer;

Assuming the module is soldered or placed over the Top Layer, it is wrong to randomly route over the Bottom Layer or
other layers, which will affect the module's spurs and receiving sensitivity to varying degrees;

It is assumed that there are devices with large electromagnetic interference around the module that will greatly affect
the performance. It is recommended to keep them away from the module according to the strength of the
interference. If necessary, appropriate isolation and shielding can be done;

Assume that there are traces with large electromagnetic interference (high-frequency digital, high-frequency analog,
power traces) around the module that will greatly affect the performance of the module. It is recommended to stay
away from the module according to the strength of the interference.If necessary, appropriate isolation and shielding
can be done;

If the communication line uses a 5V level, a 1k-5.1k resistor must be connected in series (not recommended, there is
still a risk of damage);

Try to stay away from some physical layers such as TTL protocol at 400MHz;

The mounting structure of antenna has a great influence on the performance of the module. It is necessary to ensure that
the antenna is exposed, preferably vertically upward.

When the module is mounted inside the case, use a good antenna extension cable to extend the antenna to the outside;
When the antenna is installed inside a metal case, it will cause the transmission distance to be greatly weakened.
6 FAQ
6.1 Communication range is too short

The communication distance will be affected when obstacle exists;

Data lose rate will be affected by temperature, humidity and co-channel interference;

The ground will absorb and reflect wireless radio wave, so the performance will be poor when testing near ground;

Sea water has great ability in absorbing wireless radio wave, so performance will be poor when testing near the sea;

The signal will be seriously affected when the antenna is near metal object or put in a metal case;

Power register was set incorrectly or air data rate is set as too high (the higher the air data rate, the shorter the distance);

The power supply low voltage under room temperature is lower than our recommendation, the lower the voltage, the
lower the transmitting power;

Due to antenna quality or poor matching between antenna and module.
6.2Module is easy to damage

Please check the power supply, ensure it works in correct voltage;

Please check the stability of power source, the voltage cannot fluctuate too much;

Please make sure anti-static operation when installing and using, high frequency devices have electrostatic
susceptibility;

Please ensure the humidity is within limited range, some parts are sensitive to humidity;