Ebyte 433T14S, Руководство пользователя

Страница: 26 / 34

CC1310 Wireless Module E70 Series User Manual
Copyright ©2012–2017, Chengdu Ebyte Electronic Technology Co., Ltd. 26 / 34
2 1 0 Air data rate（bps）
 The lower the air data rate, the longer the transmitting
distance, better anti-interference performance and longer
transmitting time
 The air data rate must keep the same for both
communication parties.
0 0 0
2.5kbps
0 0 1
5kbps
0 1 0
12kbps（Default）
0 1 1 28kbps
1 0 0 64kbps
1 0 1 168kbps
1 1 0 168kbps
1 1 1 168kbps
4 CHAN
7 6 5 Packet length (only for subpackage mode)
 Under continuous transmitting mode (M0=1 M1=0
M2=0), this parameter is invalid
0 0 0 16 bytes
0 0 1 32 bytes
0 1 0 64 bytes（Default）
0 1 1 128 bytes
1 0 0 256 bytes
1 0 1 512 bytes
1 1 0 1024 bytes
1 1 1 2048 bytes
Communication Channel
00H~1FH, 431~446.5MHz，（Default）04H（433M）  Model: E70 (433T14S2)/ E70 (433T14S)/ E70 (433T30S)
00H~1FH, 861~876.5MHz，（Default）0EH（868M）  Model: E70 (868T14S2)/ E70 (868T14S)/ E70 (868T30S)
00H~1FH, 907~922.5MHz，（Default）10H（915M）

Model: E70 (915T14S2)/ E70 (915T14S)/ E70 (915T30S)
5
OPTION
7 Fixed transmission (similar to MODBUS）

When it is 1, the first three bytes of each user data frame
can be used as high/low address and channel. The
module changes its address and channel when
transmitting. And it will revert to original setting after the
process is completed.

It is transparent transmission under continuous mode.
0
Transparent transmission mode (Default）
1
Fixed transmission mode
6 5 4 wireless wake-up time  This parameter is only valid for mode 4, 6.

For mode 6, the wake-up time will affect the WOR cycle
of the module, and affect the power consumption.
 For mode 4, the wake-up time decides the number of
wake-up code before transmission so as to ensure the
wake up the module in mode 6.

Generally, mode 4 and 6 shall be used jointly and the
wake-up time on both modules shall be the same.
0 0 0 500ms
0 0 1 1000ms(Default)
0 1 0 1500ms
0 1 1 2000ms
1 0 0 2500ms
1 0 1 3000ms
1 1 0 3500ms
1 1 1 4000ms
3 FEC switch
 After turn off FEC, the actual data transmission rate
increases while anti-interference ability decreases. Also,
the transmission distance is relatively short.
 Both communication parties must keep on the same
pages about turn-on or turn-off FEC.
0
Turn off FEC
1
Turn on FEC (Default)）
2
IO drive mode 
This bit is used to the internal pull-up resistor. It also
increases the level’s adaptability in case of open drain. But
0
TXD and AUX push-pull outputs, RXD pull-up inputs