Ebsray R75 Скачать руководство пользователя страница 3

Страница: 3 / 14

Publication No.: 2753-20

SECTION 3 - INSTALLATION

3.1

INTRODUCTION

NOTE:

Ebsray pumps must only be installed in systems designed

by qualified competent engineering personnel. System

design must conform to all applicable regulations and

codes and provide warning of all system hazards.

NOTE:

This installation must be performed by qualified,

competent personnel and they must, completely

read/review this entire document prior to starting any

work. If any part of this publication is unclear, obtain

clarification before proceeding with any work.

NOTE:

These instructions are additional to, and do not supersede

or override any applicable statutory, legal or regulatory

requirements.

NOTE:

New pumps contain residual test fluid and rust inhibitor. If

necessary, flush pump prior to use.

The  design,  materials  and  workmanship  incorporated  in  the
manufacture  of  Ebsray  pumps  make  them  capable  of  reliable
operation  over  a  long  working  life.  Correct  installation  is
essential to ensure a long service life.

When  the  equipment  supplied  utilises  components  other  than
those  manufactured  by  Ebsray  (e.g.  electrical  equipment,
switches, fittings or valves), refer to the original manufacturer's
data  before  installation  or  servicing  is  commenced.  Failure  to
observe these details may void the Warranty.

3.2

WARRANTY

All Ebsray manufactured pumps and equipment are warranted as
standard for one (1) year against faulty workmanship and/or
materials. Refer to Ebsray Pumps for details.

Ancillary equipment supplied by Ebsray but manufactured by
others are not cov

ered under Ebsray’s warranty.

3.3

TRANSPORTATION, HANDLING & INSPECTION

Standard  domestic  packing  is  suitable  for  shipment  in  covered
transports. When  received,  inspect  the  pump/pumpset  against
dispatch documentation and for damage.

Any damage or shortage incurred during transit should be noted
on the packing note and on both your own and the carrier's copy
of the consignment note.

Should  a  shortage  be  evident  on  receipt,  notify  Ebsray
immediately  giving  full  details  and  packing  note  number.
Additionally a claim should be made with the transport company.

When  received  on  site  the  pump  set  must  be  stored  in  a  dry
covered area.

NOTE:

Never allow water or any corrosive product to enter the

pump. Hydrostatic testing of pipework with pump installed

may void the Warranty.

If the pump/pumpset is not installed and commissioned
immediately or has been removed from service, then the pump
internals should be filled or thoroughly flushed with a light rust
inhibiting hydrocarbon fluid, In addition to this pump ports must
be sealed to exclude ingress of condensation, moisture or foreign
material.

3.4

PUMP LOCATION & PIPING CONNECTIONS

The R75, R77 R80 and R82 are designed to mount directly or
remotely to

the supply tank’s commercial internal control valve.

Pump life and performance will be significantly reduced when
installed in an improperly designed system. Before starting the
layout and installation of the piping system, review the
following:

1. When locating the pump, safety MUST be the first

consideration.

2. The discharge hose and fittings should be large enough

to minimize the pressure drop in the system. The lower
the friction loss, the higher the flow rate.

All piping and fittings MUST be properly supported to
prevent any piping loads from being placed on the pump.

Debris left in pipework will cause

significant damage to the pump and will
void the warranty.

Foreign matter entering the pump WILL
cause serious damage to the pump

Foreign matter

entering the pumps

inlet will cause

serious damage