AVA PRO - Assembly instructions for the CPX300W alarm control panel
13
/
23
see Fig. 1, item 9) and then screwed with a screw attached to the set (Fig. 6 item 4).
NOTE! All
installation activities should be carried out with power disconnected.
The SMD antenna is build-in the PCB, it means the module cannot be mounted in a metal housing!
3.4.3.
Technical parameters
Table 4. Technical parameters of the Wi-Fi module.
Type of antenna
SMD (built-in)
Chipset Wi-Fi
ESP8266EX
Supported frequency band
2.4GHz
Supported standards
802.11 b/g/n
Safety standard
WPA/WPA2
Encryption
WEP/TKIP/AES
Support for WPS
YES
Dimensions
36,5 x 27 mm
Type of antenna
SMD (built-in)
Chipset Wi-Fi
ESP8266EX
3.5.
RF433
3.5.1.
Description
A radio communication module cooperating with the CPX300W alarm control panel, powered directly
from the control panel motherboard. This module enables to add one-way detectors (e.g. MC-10, PIR-
11) to the control panel, cooperating with previous versions of the CPX2xxNWB series control panel.
- Connector for installation of the module,
- antenna connection,
- MIPOT radio module,
- Mounting hole for the screw.
Fig. 7. View of the RF433 module boards with descriptions.
3.5.2.
Module installation
The module should be inserted at an angle of approximately 30° (to minimize the possibility of damage
to the connector) into the dedicated connector on the CPX300W motherboard (labelled "RF433" - see
Figure 1, item 8) and then screwed with a screw attached to the set (Fig. 7 item 4).
NOTE!
All installation activities should be carried out with power disconnected.
