Ebode XDOM VL58 - PRODUCTSHEET, Руководство пользователя

Страница: 13 / 72

20-11-2009 13 033000=14888C
AUDIO
To transmit sound, you can use the audio out on the sound card of your PC. Please use an
adapter to convert the 3.5mm plug to a double RCA connection.
10. USING THE VIDEOLINK SET.
1. Make sure your A/V device is switched on.
2. Switch the receiving TV over to the TV transmitter going with the A/V input you plugged the
receiver into. Normally done by using the 0 or A/V button. The picture should now
automatically be there. No tuning is required. When you make use of the modulator, it should
be done in channel 36.
3. Then you can control your A/V device with your own remote control by pointing it at the IR
window of the receiver or the IR window of your A/V device. The source can also be switched
by keeping the source button at the rear side of the receiver pressed for about 5 seconds.
You can switch sources at ‘TV 1’ (where the transmitter is connected), by setting the SOURCE
button (at the rear side of the transmitter) in the right position, so the device switches over.
4. Two external A/V devices can be connected to the transmitter.
Selecting the source:
Using ‘TV2’ (connected to the receiver), you can change sources by pressing any button of a
remote control for at least 5 seconds (e.g. of your TV or A/V device). Independent of the
signal on ‘TV1’ you can select a signal for ‘TV2’.
11. FREQUENTLY ASKED QUESTIONS.
No signal.
• Check that the units are connected to mains and that the Power-switch is in the ON position
• Check that both units in the ‘ON’ position.
• Check if the receiving TV is on the correct A/V channel. Raise the small silver side
antenna to an upright position.
Signal received is poor.
• Try another channel (A, B, C or D; the channel settings has to match on both units).
• Move transmitter and/or receiver from the immediate vicinity of the connected A/V
devices. These may affect the range.
• You are (almost) out of range.
• Moving the position of the transmitter and/ or receiver a few centimetres may rectify the
problem.
Images and sound are perfect, but the infra-red return signal does not work.
Check the following:
• Depending on the local situation the 5.8GHz A/V signal can reach further than the 433MHz
signal of the IR receiver. Try again with shorter distances.
• Has the IR emitter been properly connected to the transmitter?
• Has the IR emitter been properly fixed on the IR window of your A/V device?
Do get images but no sound.
• The VIDEOLINK can send analogue stereo signals, such as e.g. Dolby Surround. Digital
systems such as Dolby 5.1 or Dolby Digital cannot be transmitted.
• You have connected an S-VIDEO (Mini-DIN) signal to the transmitter directly with an S-
VIDEO cable. This is not possible. You need to use the cables included and connect them to
the SCART or RCA output of your A/V device.