Ebode XDOM RPT - PRODUCTSHEET, Руководство пользователя

Страница: 7 / 24

Plug-In Transceiver Module Ref : RPT
July 2009 page 7 RPT
Reset appliance module addresses
1. Use a small sharp object, e.g. a paper clip, to press and hold the
setup button until the green led turns on. (about 3 or 4 seconds)
2. Release the button, the led will blink red and green and then
turn off.
3. When the red and green LEDs are off, the module is reset.
Tips
- Knowledge base available on www.ebodeelectronics.eu .
Can I plug transceiver module into a power strip?
This is no problem with a simple power strip however you can not use the module
with a surge protected power strip.
Operating the RPT Module
The transceiver is not responding to RF commands?
- Check and/or change the remote control battery.
- Reset the transceiver (see paragraph 4) and reprogram the address.
- Then, proceed again using learning mode as explained in 2.
The RPT does not respond to command sent via the power line?
- Reset the RPT (see paragraph 3) then initialize the address.
- Then, proceed again using learning mode as explained in 2.
Functions enabled by a wireless transmitter (EM, TPC, IMRF, etc..)
ON / OFF key
Turns the lamp or appliance On & Off