page 2 of 6
Electrical voltage and current
DANGER
Electrical voltage
Regularly check the electrical
equipment of the product.
Eliminate immediately loose
connections and defective cables.
Safety and protective functions
DANGER
Missing safety device and faulty
protective equipment.
Without protective equipment severe
injuries can occur, e.g. by taking hold of
the rotating equipment.
Operate the product with protection
guards only.
Electromagnetic radiation
Electromagnetic compatibility (EMC) may affect the system integration
of the product due to interaction.
Ensure the electromagnetic compatibility of the entire system.
Moving parts
DANGER
Self-starting product
If voltage is applied, the motor
automatically restarts after a mains
failure or when blocking has been
eliminated.
Do not stand in the danger zone of
the product.
Switch off the mains voltage when
working on the product and secure
against switching on again.
DANGER
Rotating impeller
Contact with the impeller may result in
injuries. Long hair, loose-fitting
garments and jewellery can be caught
and pulled into the product. Risk of
injury.
Before starting the product, ensure
that it is securely fixed and that the
guards are in place.
Do not wear loose-fitting garments
or jewellery when working on
moving parts.
Protect long hair by wearing a hair
net.
WARNING
Parts transported by the airflow
The product can transport small parts
in the airflow and catapult them out.
Ensure that there are no loose
small-parts in the intake and
exhaust area.
Do not stand in the danger zone of
the product.
CAUTION
High risk of fire spreading
Can cause fire to spread.
Never direct the airflow
(intake/exhaust side) at a potential
source of fire.
Hot surface
CAUTION
High temperature at motor housing.
Risk of burns
Provide adequate protection against
accidental contact.
Transport
Only transport the product in its original packaging. Secure during
transport.
The vibration values, temperature and climate ranges should not
be exceeded during transport.
Storage
Store the device, partially or fully assembled, in a dry place,
protected against the weather and free from vibration, in the
original packaging in a clean environment.
Protect the device against environmental effects and dirt until final
installation.
To guarantee trouble-free operation and the longest possible
service life do not store the device for more than one year.
Even devices explicitly intended for outdoor use are to be stored as
described prior to commissioning.
Maintain the storage temperature, see Chapter 3, Technical Data
Cleaning
NOTE
Product damaged during cleaning
Do not clean the product using a
water jet or pressure washer. Do
not put any pressure on the rotor.
Do not use cleaning agents
containing acids, caustic solutions
or solvents.
Disposal
When disposing of the product, observe all requirements and
regulations that are relevant in your country.
Содержание 4112 N/2HU
Страница 6: ......
