ZEN
EN
13
www.eberg.eu
Replacing the batteries in the remote control.
Before operating with the remote control, remove the protective foil from the remote control battery
compartment (Fig. 5).
To replace the battery in the remote control, release the lock and pull out the battery drawer located on
the back of the remote control (Fig. 6).
Fig. 5
Fig. 6
Remote control
Insulating film
Battery carriage
Release Tab
PULL
Push
Open
A suitable battery for the remote control is CR2025 (3V).
ON/OFF button
Fan speed
Oscillation
Timer
Position the Tower Fan on a flat and even surface where it won’t cause obstruction or injury. Connect the
appliance to the suitable mains outlet. The Tower Fan will bleep and display the current room temperature
to indicate the appliance is in the stand-by mode.
After connecting the appliance to the power source, the device will be in the stand-by mode. After
pressing the on/off button, tower fan will start working. Default setting is middle speed. Now you can
switch into other modes. Press again this button to turn the device off.
Press this button to select MIDDLE, HIGH, or LOW fan speed. MIDDLE is the default speed.
Use this button to enter the oscillation function. The fan body will rotate horizontally relative to the base
(left to right and right to left). Press again to turn off the oscillation.
Use this button to set the time after which the device will automatically turn off. The fan run time can be
set hourly in range from 1 to 12 hours.
VI. OPERATION INSTRUCTIONS
Ionization
LED display
Use this button to activate the ION function. Press again to turn off.
After setting all desired functions, LED will automatically display room temperature again.
