ROT
EN
14
www.eberg.eu
•
Warning! If the heating panel is splashed with water or immersed, disconnect the device immediately
by removing the plug from the power socket.
•
Warning! Make sure your hands are dry when you touch the device. Do not touch the device, plug or
cord witch wet hands, otherwise there is an electric shock and risk of injury to life or health.
•
Save these instructions.
2. UNPACKING AND MOUNTING INSTRUCTIONS
Before use, carefully check the contents of the kit. Take the heating panel out of its packing and make sure
that the devices is in good condition. Do not start the device with a damaged cable or housing. Before
commissioning, make sure that the mains voltage parameters are consistent with the data given on the
rating plate of the device.
2.1. WALL MOUNTING INSTRUCTIONS
1. Mark the positions of the four holes to be drilled
on the wall, and drill the holes with the drill bit.
Make sure the distance between each holes is
same as the round holes on the brackets at back
of the heater.
2. Insert the plastic rails fitting into the holes.
3. Insert the metal screws into the plastic rails.
4. Lift the heater and aim the four round holes on
the brackets at back of the heater to the 4 screws
on the wall.
