MIR
GB
10
www.eberg.eu
DISPLAY AND CONTROL PANEL
III. OPERATING THE DEVICE
Enable / Disable / Set the
humidification level
Activate the humidifying
function
Humidify / temperature
Functions of the control buttons
The device will start up after pressing the button:
•
When the humidifier is turned on, pressing this button again will take you to the humidifying level
setting - the volume of the mist coming out of the nozzle.
•
Each press of the button increases the humidifying level by 1. There are three levels of humidifying
(1-2-3).
•
When the humidification level is set to level 3, pressing the button again will turn the humidifier off.
When the humidifier is turned on and one of the three humidification levels is set, pressing the
button will start the humidification process.
•
The same button is used to set the desired humidity level in the range of 40% - 80% RH.
•
Each press of this button increases the humidity level setting by 5 percetage points (40% - 45% - 50%
... 80%).
•
If the ambient humidity is higher than the user-set humidity level, the humidifying function will not
start.
•
If the ambient humidity is lower than the user-set humidity level, the humidifying function will start
shortly after the setting is completed.
After completing the process of setting the humidifier operating parameters, the display will show the
ambient temperature, then the ambient humidity level and will alternate between these parameters.
Attention!
•
The top cover must be closed during operation.
•
When the water in the tank is exhausted, the humidifier will turn off automatically.
Filling the water tank
•
Before starting the process of adding water, disconnect the device from the power supply.
•
To pour water into the tank, lift it disconnecting it from the base of the device, turn the tank over
and unscrew the cap.
•
Only pour water into the tank. Do not pour more water than the maximum level marked on the tank.
