7
TROUBLESHOOTING
For best results, do not use batteries with power strip indicators (such as
Duracell Ultra Power batteries and Duracell Ultra Advanced with Powercheck).
Should you wish to continue to use these batteries, please be sure that all
power strips are facing forward when placed in the battery compartment.
In some cases, it may also help to remove, reinsert and push the batteries
forward ensuring proper contacts are being made. If batteries have been
installed correctly the Red LED light on the remote control will begin to blink
once you turn the remote ON/OFF switch to the ON position.
Set the ON/OFF Switch to the ON
position.
Recharge the helicopter battery.
If this does not work, replace
the batteries in the remote and
fresh batteries.
Helicopter sud-
denly stops and
ight
or seems to have
weak performance
Weak battery
power
Recharge the helicopter battery.
If this does not work, replace
the batteries in the remote and
fresh batteries.
Propellers are not
moving
Helicopter is
Weak battery
power
Batteries are not
making contact
with battery leads
on the remote
Interference of
another remote
controlled device
Remove and reinstall the batteries
being certain they are installed in the
right direction and making proper
contact with the battery leads.
Avoid all other remote controlled
devices running on the same
channel/frequency.
Remote is not
turning on
Loss of control
Helicopter
spinning out of
control
Incorrect trim
adjustment
Adjust the trim as shown above
nd the proper adjustment.
Cause
Correction
Helicopter is not
synced with the
remote control
Press throttle all the way up and all
the way down to sync. Slowly move
the throttle up and chopper will
begin to ascend.
Problem
Helicopter is
not responding
to remote
