Acoustic Performance Partnership
Eastern Acoustic Works
KF860 Rigging Hardware Tech Note
One Main Street, Whitinsville MA, 01588 USA • Phone 508/234-6158 • Toll Free 800/992-5013 • Fax 508/234-8251 • Web http://www.eaw.com • email [email protected]
RIGGING HARDWARE TECH NOTE
KF860
AC
O
US
TIC
AL
PER
FORMANCE PA
RTN
ER
SH
IP
5
Roll the Cart under Cab/Pallet from the rear and
center the Cart as shown. Lock the Cart’s Flyclip
into the Flypoint centered on the back of the
Module. Using the Crank Handle, adjust the
Cart’s large wheels to the top position. Pull the
Cart back and lay the Module/Pallet down.
CABINET END BRACKETS
ADJUSTABLE
RIGGING PLATE'S
V-GROOVES
CASTER PALLET LATCH
ACCESS HOLE
SAFETY PIN
ROTATING CAM
ROTATING CAM
ADJUSTABLE
RIGGING PLATE
TENSION SPRING
SAFETY PIN
6
Lower the Flybar and align the Rigging Plates
so they fit into the Module’s Top End Brackets.
As they engage, you will see the spring-loaded
Rotating Cams snap onto the Rigging Plates’
V-Grooves. Once both sides are engaged, rest
the entire weight of the Flybar onto the
Module. Each Top End Bracket has two holes
with a yellow ring around them. Fully insert the
Safety Pins into these holes, 2 per side, 4 in all.
CART
LARGE WHEEL
CABINET
FLY CLIP/FLY POINT
NOTCH
CASTER
PALLET
CRANK HANDLE
3
Raise the Flybar to a height of 7
feet.
4
Roll the first Module on its Caster
Pallet beneath the Flybar so the
top of the Module faces front. (The
end of each Module has a notch
that faces the Module’s top
surface)
