background image

Page 5

4 . 6         O p e r a t i n g   T i p s

Do NOT drive any of your electronic equipment into clipping, particularly the power
amplifiers. This can easily damage the loudspeaker.

If driven into clipping, even the amplifier with a power output rating lower than EAW’s 
power rating can cause damage to a loudspeaker.

•  

Avoid sustained microphone feedback. This can quickly cause failure of mid and 
high frequency drivers.

Avoid extreme boosts on equalizers as these can cause excessive input to the drivers 
at the boosted frequencies. Generally, cutting frequencies is preferred to correct for 
frequency response problems. These problems include attenuating feedback 
frequencies or reducing excessive energy at certain frequencies due to room acoustics.

With appropriate signal processing, your loudspeaker should produce exceptionally 
good sound. If used in a room with problematic acoustics, there is little you can do 
to overcome room problems with electronic adjustments. Your best solution is careful 
placement and aiming of the loudspeaker so that most of the sound is directed only at 
the audience. 

EAW loudspeakers are capable of sound levels that can be damaging to human 
hearing. Take precautions so that audiences are not exposed to such levels. If you must  
expose yourself to these kinds of volume levels, wear adequate hearing protection.

Take care when moving or lifting the loudspeaker. Injury to you or damage to the 
loudspeaker can result from careless handling.

Section 5  

Service and Maintenance

5 . 1

W a r r a n t y

Your EAW loudspeaker is warranted against factory defects for a period of six years (five years for
Weather Protected products) from the date of purchase. See your warranty card for the complete
warranty statement.

IMPORTANT:

Retain your sales receipt as this is proof of your warranty coverage.

5 . 2

H o w   t o   C o n t a c t   E AW   S e r v i c e

Eastern Acoustic Works

Tel 

800-992-5013, ext. 6001 (USA only)

EAW Service Department

Tel  

508-234-6158, ext. 6001

One Main Street

Fax  

508-234-3776

Whitinsville, MA  01588  USA

e-mail  

[email protected]

Web Site www.eaw.com

5 . 3

L i t e r a t u r e   a n d   S p e c i f i c a t i o n s

Eastern Acoustic Works

Tel   

800-992-5013, ext. 253 (USA only)

EAW Literature Department

Tel   

508-234-6158, ext. 253

One Main Street

Fax  

508-234-8251

Whitinsville, MA 01588 USA

e-mail   [email protected]

Web Site  www.eaw.com

Содержание 425017









Отзывы: