20
www.eaton.com/wireless
call toll free: 1-800-663-8806
DMAN-4096-01 R1
Service Mode: Field Configuration (continued)
Light Legend
Solid
Slow
Flash
Fast
Flash
Red
Solid
Green
Solid
Red & Green
Alternating
Yellow
Solid
Changing the Configuration
NOTE:
An 18-digit Configuration Code is required to complete these steps. Refer to the
Configuration Code
section on the previ-
ous page for directions on how to determine this code.
A. The cap is held on by two plastic
tabs at opposing sides, which can
be unlatched as shown using a
screwdriver. Once the cap is free,
the R160 can slide open.
B. Supply power to the receiver. The
(E-STOP) light and the (LINK) light
will come on RED and the
(STATUS) light will come on
GREEN.
A.
1. Opening the R160 Case and Power R160
ESTOP FAULT LINK STATUS
B.
5 6
7 8
3 4
1 2
9 0
On the TS110, press the second right Button from
the top
to enter the Base Station output Config-
uration Mode.
The TS110 will blink out the currently programmed
sequence on the red LEDs of the 10 user buttons.
2. Place TS110 into Configuration Mode
3. Enter Configuration Mode Pass Code
A. Enter the first 10 digits of the Configuration Code.
(Refer to the
Configuration Code
chart on the bottom
of the previous page to determine this code.)
B. Press the green button once to accept.
C. Enter the remaining 8 digits of the Configuration Code.
NOTE:
While waiting for the user to enter the Configuration
Code, the TS110 will use the red LEDs of the ten
user buttons to blink out the currently programmed
sequence.
NOTE:
All systems come preconfigured with the default code of
5188888888
88888888.
5 6
7 8
3 4
1 2
9 0
1
3
5
7
9
2
4
6
8
a
NOTE
: Both the Configuration Code and configurator use
letter codes to represent the values of 10 to 13.
Press button “0” to specify the letter “a”. Press and hold
down button “0” while pressing buttons “1”, “2” or “3” to
specify the letters ”b”, “c” and “d” respectively.
