Fig. 1 S801V Shown with Lugs Installed on Load Side
Without Terminal Cover in Place
FOR S801V/S811V
1. Remove soft starter terminal cover by removing the four #6 cover screws. Once screws have been removed, slide
cover off soft starter.
2.
Line Side -
Fasten lugs to soft starter with three each
2 inch
long allen head cap screws, 1/4 lock washers, and
1/4 flat washers per pole. Tighten to 120 LB-IN (13.6 N-m). For the EML40, attach lugs and tighten 1.75 inch screws
to 300 LB-IN. Discard remaining hardware.
Load Side -
Remove shipping bolts. Position and fasten lugs to soft starter with three each
3 inch
long allen head
cap screws, 1/4 lock washers, and 1/4 flat washers per pole. Tighten to 120 LB-IN (13.6 N-m). For the EML40,
attach lugs and tighten 2.75 inch screws to 300 LB-IN. Discard remaining hardware.
3. Replace terminal cover. Tighten the four #6 cover screws to 5 LB-IN (0.6 N-m).
NOTE:
The cover cannot be used
with the EML40 kit.
4. When the EML40 Kit is used, verify that 1/2 inch clearance is maintained between the poles.
FOR S801T/S811T, and S801U/S811U
1. Remove soft starter terminal cover by removing the two #6 cover screws. Once screws have been removed, slide
cover off soft starter.
2.
Line Side -
Fasten lugs to soft starter with one each
2 inch
long allen head cap screw, 1/4 lock washer, and 1/4
flat washer per pole. Tighten to 120 LB-IN (13.6 N-m). Discard remaining hardware.
Load Side -
Remove shipping bolts. Position and fasten lugs to soft starter with one each
3 inch
long allen head
cap screw, 1/4 lock washer, and 1/4 flat washer per pole. Tighten to 120 LB-IN (13.6 N-m). Discard remaining
hardware.
3. Replace terminal cover. Tighten the two #6 cover screws to 5 LB-IN (0.6 N-m).
Pub49000
Page 2
Effective 05/06
IT SS#10680
Milwaukee, WI U.S.A.
DISCONNECT ALL POWER BEFORE PERFORMING ANY WORK!
Fig. 2 S801V Shown with EML40 Lugs Installed on
Load Side - Terminal Cover Cannot be used with
EML40 Kit.
1/2 MIN.
CLEARANCE
