IL158004EN
Surge Protective Device
Page 2
Rev. 2 – December 2017
2 RSPF Series Catalog Number
Each Eaton RSPF Series SPD is identified by a Catalog
Number, see example in
Table 1
. The Catalog Number
identifies the parameters that make up the unit.
Table 1. Catalog Numbering System
For example, an RSPF Series SPD with a Catalog
Number of RSPF2403MA1A, where:
RSP = RSP Series
F = Surge Frame
240 = Voltage Code
3 = Number of Phases
MA = Type and current rating of panel
1 = Feature Package
A = Application
See
Section 10
.
Ordering Guidelines
for additional
voltages, features, and service options.
3 RSPF Series Product Nameplate
Each Eaton RSPF Series SPD has a Product Nameplate
affixed to the front of the unit that identifies Catalog
Number and operating parameters. The Catalog
Number consists of letters and numbers which identify
the RSPF Series, surge frame, voltage code, number of
phases, panel bus rating, feature package, and
application as shown in
Figure 1
.
Figure 1. RSPF Series Product Nameplate
4 Installation
WARNING
A LICENSED/QUALIFIED ELECTRICIAN MUST
COMPLETE ALL INSTRUCTIONS IN THIS MANUAL
IN ACCORDANCE WITH THE NATIONAL ELECTRIC
CODE (NEC), CANADIAN ELECTRICAL CODE (CEC),
STATE, AND LOCAL CODES, OR OTHER
APPLICABLE COUNTRY CODES. ALL APPLICABLE
LOCAL ELECTRICAL CODES SUPERSEDE THESE
INSTRUCTIONS.
INSTALLING AN SPD THAT IS IMPROPERLY RATED
FOR THE ELECTRICAL SYSTEM VOLTAGE COULD
CREATE A POTENTIALLY HAZARDOUS CONDITION,
RESULTING IN INJURY OR EQUIPMENT DAMAGE.
CHECK THE VOLTAGE-RATING LABEL LOCATED
ON THE FRONT OF THE SPD TO VERIFY THAT THE
ELECTRICAL SYSTEM’S VOLTAGE AND WIRING
CONFIGURATION ARE THE SAME AS THE SPD.
FOR USE ON CIRCUITS DELIVERING UP TO 200,000
RMS AMPS. CONVIENT Á DES CIRCUITS
PRODUCISANT AU PLUS 200,000 A EFF.
BEFORE MOUNTING THE SPD IN AN ELECTRICAL
SYSTEM MAKE SURE THERE IS NO VOLTAGE
PRESENT WHERE WORK IS TO BE PERFORMED.
VOLTAGES IN ENERGIZED EQUIPMENT CAN
CAUSE INJURY OR DEATH.
4.1
Pre-Installation Checklist
o
Does the panelboard have a 3 pole FD Frame
breaker space available.
o
Does the panelboard have a panel with an
opening that will allow the front of a RSPF
Series SPD to protrude through after installation.
o
Does the panelboard have 3 pole FD-Frame
phase connectors.
o
If the answer was “No” to any of the three
previously listed conditions, contact the
EatonCare Technical Resource Center at: 1-
800-809-2772, Option 4, sub-option 2 to
purchase either Connector Kit
Catalog#:
KPRL3AFD3
(3-pole) for use in panel type
PRL3a or Connector Kit
Catalog#: KPRL4FD
(3-pole) for use in panel type PRL4. These
connector kits include phase connectors,
deadfront cover, filler covers, hardware and
instruction sheet.
Содержание RSPF Series
Страница 11: ......
