Eaton RPM-3U, Руководство пользователя, Страница: 19 / 34

Eaton Rack Power Module 164201675—Rev 02 13
(Optional) Use the supplied labels to mark the equipment loads.
11. Turn on utility power where the RPM-3U/3Ui is connected.
The Power indicator on the RPM-3U/3Ui illuminates.
Verify that the Alarm indicator is off. If the Alarm indicator is illuminated, see “ Table 25 ”.
12. Make provision for any required cord retention or strain relief.
13. For each receptacle to be monitored, turn its circuit breaker on the RPM-3U/3Ui front panel to the ON ( | )
position.
NOTE If power to the RPM-3U/3Ui is interrupted, check each circuit breaker and reset if
necessary.
22..1100 A Addvvaanncceedd M Meetteerriinngg IInnssttaallllaattiioonn ((O Oppttiioonnaall))
NOTE Follow these instructions only if you ordered the Advanced Metering option.
The Power Xpert Gateway Series 1000 Card (shown in Figure 9 ) is factory-installed in the X-SlotR
communication bay on the front of the RPM-3U/3Ui.
To connect the cables and configure the card:
1. Locate the Power Xpert Gateway Series 1000 Card Quick Start Instructions included with the RPM-3U/3Ui.
2. Perform all the steps in the quick start instructions, ignoring the initial few steps that describe how to
install the card in a PDU.
The quick start instructions direct you to:
• Connect the Ethernet cable.
• Connect the configuration (serial) cable.
• Configure IP Address assignments.
3. For more detailed information about installing the card or using Advanced Metering, download the Power
Xpert Gateway Series 1000 Card user's guide from the Documentation page on the Power Xpert card once
the card is accessible on your network or from www.eaton.com/powerxpert.
Figure 9. Power Xpert Gateway Series 1000 Card
Ethernet
Port 2
Ethernet
Port 1
Configuration
(Serial) Port
Advanced Metering Installation (Optional)