Weight: 13 oz. (370g);
Cooling Method:
The PXES6P Switches are designed with a closed case to withstand dirt and use special thermal
techniques to transfer heat to the outside of the case for cooling.
Alarm Relay Terminal Block, two screw terminals:
Internal 60VA relay contact: Open for power off, closed for power On (Hardware).
Power Supply:
This product is intended to be supplied by a Listed, Direct Plug-In power unit, marked “Class 2”, or a
Listed ITE Power Supply, marked “LPS”, which has suitably rated output voltage (i.e. 9vdc, 12vdc,
24vdc, 48vdc), and suitably rated output current (i.e. 100mA to 500mA).
AC Power Supply (using an external power adapter):
9
This model has a (8-15) VDC output with 6ft long cord
and a 2.5mm ve jack. The
external AC power supplies are temperature rated to match the Switch ratings.
External AC Power Supply Environmental Ratings (-25 to 60°C):
Hardened, factory floor temperature rated. Input: 6ft AC 3power cord to IEC 320 connector on
the 100-240vac 47-63Hz external power adapter. Output: 12vdc, 1.25Amps.
Direct DC POWER SUPPLY:
Built-in terminal Block for +, -, ground along with 24VDC jack 24V DC
internal
(range 10 to
36V DC),
Power Consumption
: See Section 3.6.
Note 1:
the 12V DC jack can be used for dual source DC input
using an AC adapter and the DC terminal block. Power supply
protection is provided by internal diodes.
See also 3.6
10
Note 2:
The Direct DC power floats. The user may ground either “+” or “-” if desired. Power
Consumption: 7.0 watts typical, 9
watts max.
Port Connectors:
RJ-45 Ports: support 100BASE-TX and 10BASE-T with auto-cross (MDIX). They are
shielded 8-pin female connectors for shielded (STP) and unshielded (UTP) Cat 3, 4, 5
cables.
One Fiber optic port: On the PXES6P Series it is 100Base-FX with a “fiber flavor”
choice of multimode ST connector. (By default factory settings is at “Full” duplex on
fiber ports)
LED Indicators (Front):
POWER: Steady ON when power applied
10/100: Steady ON for 100Mbps; OFF for 10 Mbps (copper ports only)
11
