Eaton Power Xpert Meter 2000, Инструкция по эксплуатации

Страница: 12 / 16

12 Connecting a NetComm Wireless NTC-140W Router to an Eaton® Network Card P-164000722—Rev 04
TTrroouubblleesshhoooottiinngg
S Siiggnnaall S Sttrreennggtthh
The biggest risk for the router is low signal quality. As an initial test, observe AT&T cell phone signal strength in
the area of installation.
To quantify the signal, connect an Ethernet cable to the router. Once connected, open an internet browser and
navigate to
192.168.1.1 .
Log into the router’s Status page (see Figure 23 ) using the credentials:
Username: admin
Password: admin
On the Status page, observe the Signal strength (dBm) and position the router to maximize the value.
If the signal is weak, an external antenna may be required. The external antenna replaces the 3G antennas
provided with the router. Once connected, position the external antenna to maximize the signal strength.
Figure 23. NetComm Wireless Status Page
Connecting a NetComm Wireless NTC-140W Series Router to an Eaton ® Network Card