2
EATON
IB520031EN
Installation Instructions
Installation Instructions - LSR2B / LSSQ2B Commercial LED Rough-In
INSTALLATION
Surface Mount Installation
1. Install cylinder mount plate to junction box
(see figure 1).
a. The plate has a 45-degree adjustment (applicable for
Square Cylinders).
2. Install “canopy” using screws provided to the mount
plate (see figure 2).
3. Hook cylinder tether to the junction box or the mount
plate.
4. Wire unit per wiring diagram (see electrical section).
When complete, push wires into junction box.
5. Position cylinder underneath mount plate hooks/snaps.
Lift into place and twist until locked (see figure 3).
6. Insert trim into the opening of the LED module until it
is flush against the cylinder (for round cylinders) or flush
against the square trim plate (for square cylinders).
7. For wet location, covered ceiling applications, apply
caulk between the canopy and the cylinder as well as
the ceiling and the canopy.
Attach “Canopy”
To Mount Plate
45-Degree Slot For
Rotational Adjustment
Figure 1.
Figure 2.
Figure 3.
Bring Cylinder Close
To Ceiling And Twist
Clockwise
Attach Tether To
Mount Plate Or
Junction Box
Twist Until Locked
Mechanism Shown Without
Cylinder For Clarity
Fit Hooks Through
This Opening
Mount Plate Snap
Hooks
Mechanism Shown In Locked
Position Without Cylinder
Body For Clarity
Cylinder Has Been Rotated
Into Locked Position
Cylinder Mount Plate
