Eaton Moeller MFD-80, Аппаратное обеспечение и инженерия

Страница: 29 / 41

25
05/08 AWB2528-1611en
3 Setting and commissioning the
device
Settings You can display and modify the station address (node ID),
baud rate, backlight and contrast via the MFD80 display.
Press the DEL and ALT buttons simultaneously to call up the
Setup menu.
Figure 24: Setup menu
Use the
Í
and
Ú
buttons to select the required parameters.
Press OK to then switch to Entry mode. Entry mode enables
you to change the setting using the
ú
and
í
buttons. Pressing
the OK button again stores the actual value.
Pressing the
Ú
button in the last line causes the current soft-
ware version of the device to be displayed.
NodeID : 2
Baud rate:125
Backlight:100%
Contrast: 100%
h The device is provided with an automatic baud rate detec-
tion feature. A setting for this is therefore not normally
required. If the MFD4-CO is the only station on the bus,
and if the master does not support automatic baud rate
detection, the baud rate can be set via the display.