Eaton Mini PDU, Инструкция по установке и эксплуатации

Страница: 19 / 36

Eaton 30 kVA Mini Power Distribution Unit Installation and Operation Manual 164001117—Rev 01 7
C Chhaapptteerr 33 IInnssttaallllaattiioonn
33..11 B Biillll ooff M Maatteerriiaallss
Table 3. Bill of Materials
Quantity
Part Number Item
1 11900003 30 kVA Mini PDU
1 MIS68130
Cable Ladder, aluminum (12”W x 4”D x 72”H)
1 MOD67210 Kit Mini PDU Customer Cables
33..22 R Reecceeiivviinngg aanndd U Unnppaacckkiinngg tthhee M Miinnii P PD DU U
30 kVA Mini PDUs are shipped bolted to pallets and protected by two layers of external plastic covering. Units
are first covered by a large plastic bag and then shrink-wrapped. Finally each unit is secured to its pallet with
metal retaining bands.
Accessories may be shipped on the same pallet or separately.
For moving the Mini PDU on its pallet, Eaton recommends that you leave the retaining bands intact until you
have moved the unit to a convenient location for removing it from its pallet.
NOTE Inspect the shipped unit twice, upon receipt and after removing packaging materials.
1. Upon receiving a pallet and before removing packaging, inspect the packaging for visible damage. If
damage is evident notify the shipping company and Eaton (see
1.7 Getting Help ).
File any damage claims with the shipping company at time of delivery. Damage must be noted on the bill
of lading. Failure to properly document all damage may result in the unit’s warranty being voided.
• Metal retaining bands are under tension. Exercise caution when cutting them.
• Wear protective clothing including eye, face, and hand protection when cutting retaining bands.
2. Carefully cut the retaining bands, making sure that they do not scrape the exterior of the unit or scratch the
paint.
3. Carefully remove the outer layer of protective shrink wrap from the unit and the interior plastic covering
bag. Use care to not puncture or scratch the Mini PDU with cutting tools.
4. After removing the outer external packaging, inspect the unit’s exterior panels and doors for any visible
damage such as scratches, dents, or cracks. If you discover any damage, notify the shipping company and
Eaton Service (see
1.7 Getting Help ).
33..33 R Reeqquuiirreedd C Clleeaarraanncceess
• Service clearance: Front 36”, one side 36”, rear 36”
• Ventilation clearance: Minimum 6” one side
See detailed drawings in Chapter 7 Appendix: 30 kVA Mini PDU Drawings .