2
EATON
IB519090EN
Installation instructions
Installation Instructions – VT4S LED Vaportite Luminaire Installation
Mounting
The VT4S supports the following 4 mounting options;
(Rigid mount not for use in gymnasiums).
Hanging Loope:
Each unit is supplied with 2 hanging loops.
Install each hanging loop end in the hole on the mounting
strap attached to the fixture. Locate appropriate hangers on
the ceiling for chain or other mounting hardware desired (by
others) and attach to loop hangers. (Figure 1)
Figure 1.
Figure 2.
Figure 3.
Figure 4.
Single Point Mountinge:
Option sold separately. Remove
the mounting straps (Qty 4) and remove the center latches
on the long side of the fixture (quantity 1 latch per side).
Reinstall the mounting straps (Qty 2) with the additional
mounting tabs (Qty 2) in the center of the fixture on the
long side, in the locations where the latches were removed.
Then place the mounting beam on the backside of the
housing and press the mounting tab through the duckbill
spring clips on the mounting beam. Use #6 screws (not
supplied) to secure the mounting tab to mounting beam.
(Figure 3 & 4)
Pendent Mounte:
This is a specific fixture with a unique
housing. Remove the lens and gear tray using the interior
access instructions. Locate the hub (figure 7) supplied with
the fixture, remove the locknut and insert the hub into
the hole in the backside of the housing with the O-ring on
the outside of the fixture. Thread the hub locknut onto the
hub and tighten firmly, do not allow the outside portion of
the hub and O-ring to rotate when tightening. Use thread
sealant for the connection to the pendent mount hub. Then
reinstall gear tray and lens. (Figure 5, 6 & 7)
Mounting Strap
Mounting Strap
Mounting Beam
Mounting Tab
Surface Mounting Brackete:
Option sold separately. Locate
the mounting straps on the side of the fixture, push the
mounting bracket end onto the mounting strap until the
engagement teeth are properly engaged in the holes on the
mounting strap, repeat for other side. (Figure 2)
Mounting Bracket Engagement Teeth
Mounting Strap
Engagement Holes
Push Until The Mounting Bracket And
Mounting Strap Are Properly Engaged
