Page 3
Red means Alert
Press
Y
Secure all your windows and doors.
Make sure the system is idle, and that you can
hear the warning tones from the keypad.
1. Press the appropriate button on the remote
control, either full set (A) or part set (B).
The keypad sounds the exit warning tone.
2. Leave by the exit door and make sure it is
closed properly (if you have not already done
so).
See
Setting the System
opposite.
Set by Two-Way Fob
Note: You must program the control unit to
recognise (“learn”) a two-way fob, see
the Administrator’s Guide.
If The System Will Not Set
If one of the detectors is still active when you try
to set the system then you will not hear the exit
warning tone.
What happens next depends on how the install-
er has set up your system.
a) Try pressing A once more on your remote
control (or on the two way fob). If the in-
staller has programmed the system to do so
then it will carry on and set, omitting the ac-
tive detector.
b) If the system will not set on the second press
of button A (or )then you will have to go to
the keypad and set the system from there.
(The two way fob will flash all of its LEDs
red.)
Dealing with Alerts
(Why is it Beeping?)
From time to time the control unit may detect
that there is a problem with the system. It will try
to inform you of this by starting an alert. During
an alert the rim of the navigation pad glows red,
and the keypad will give an short “beep” every
few seconds.
To see the cause of the alert:
1. Make sure the system is unset and that the
keypad display shows the standby screen.
2. Press
Y
.
The display asks you to key in an access
code.
3. Key in a user access code.
The bottom line of the display shows a mes-
sage describing the most recent active alert.
If you press
or
then the system will
show you any other alerts that may be ac-
tive.
4.
Either:
Press
Y
to acknowledge that you
have read the alert.
If there are no other alerts the rim of the nav-
igation pad will glow green and the keypad
will return to its standby screen. In addition
the keypad will stop beeping.
Or:
Press
. The rim of the navigation pad
will stay red and the system will show the
Secure all your windows and doors.
Make sure the system is idle, and leave the pro-
tected premises.
1. Press the appropriate button on the fob, ei-
ther full set or part set .
The LED by the button you pressed will flash
red.
The system sets immediately.
After a few seconds the LED by the button
you pressed will flash green to confirm that
the system has set.
Unset by Remote Control
1. Enter by the designated entry door.
2. Press on your remote control.
The system unsets. At this point the system dis-
plays the standby screen.
Unset by Two-Way Fob
1. Press on the two way fob.
The LED by the button you pressed flashes
red.
The system unsets.
After a few seconds the LED by the unset
button flashes green to show that the system
is unset.
Part Set*
Full Set*
Unset*
Query
Two-Way
Fob
LEDs
LEDs
*In a ward-based system,
the button sets/unsets
only the ward the fob is
assigned to.
(Default settings
shown)
