Eaton
1000 Eaton Boulevard
Cleveland, OH 44122
United States
Eaton.com
© 2015 Eaton
All Rights Reserved
Printed in USA
Publication No. IL019107EN / Z17345
October 2015
Eaton is a registered trademark.
All other trademarks are property
of their respective owners.
Magnum DS switchgear terminal boots
for cable connections—installation
Instruction Leaflet
IL019107EN
Effective October 2015
Step 2
As shown in
Figure 2
, the openings for each cable must be cut into
the boot at installation. Using the raised areas as a guide, cut an
opening for the passage of each cable. Also, cut a slit between the
cable opening and the center flange, to permit insertion of the cable
into the boot. Unused raised areas (cable access points) will remain
as boots. Boots are designed for multiple cable options and for
universal fit whether cables are going up (as shown) or down.
Step 3
As shown in
Figure 2
, following encasing of the cables in the boot,
close the seam with plastic wire ties in each hole provided along the
perimeter of the boot. The exposed copper and terminal connections
should be effectively isolated inside the boot.
Step 2
Step 3
Figure 2. Steps 2 and 3
Disclaimer of warranties and
limitation of liability
The information, recommendations, descriptions, and safety
notations in this document are based on Eaton’s experience and
judgment, and may not cover all contingencies. If further information
is required, an Eaton sales office should be consulted.
Sale of the product shown in this literature is subject to the terms
and conditions outlined in appropriate Eaton selling policies or other
contractual agreement between Eaton and the purchaser.
THERE ARE NO UNDERSTANDINGS, AGREEMENTS,
WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR
MERCHANTABILITY, OTHER THAN THOSE SPECIFICALLY SET
OUT IN ANY EXISTING CONTRACT BETWEEN THE PARTIES.
ANY SUCH CONTRACT STATES THE ENTIRE OBLIGATION OF
EATON. THE CONTENTS OF THIS DOCUMENT SHALL NOT
BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN
THE PARTIES.
In no event will Eaton be responsible to the purchaser or user in
contract, in tort (including negligence), strict liability, or otherwise
for any special, indirect, incidental, or consequential damage or
loss whatsoever, including but not limited to damage or loss of
use of equipment, plant or power system, cost of capital, loss of
power, additional expenses in the use of existing power facilities,
or claims against the purchaser or user by its customers resulting
from the use of the information, recommendations, and descriptions
contained herein.
The information contained in this manual is subject to change
without notice.
