Eaton M-Max series, Руководство по эксплуатации

Страница: 189 / 199

04/10 MN04020001Z-EN
List of parameters
185
P8.13 715 - rw Underload protection
at zero frequency 10.0 - 150 % 98 10.0
P8.14 733 - rw Field bus error 0 = Deactivated
1 = Warning (AL 53)
2 = Error (F… 53)
stop function according to P6.8 98 2
P8.15 734 - rw Fieldbus,
interface error 0 = Deactivated
1 = Warning (AL 54)
2 = Error (F… 54 )
stop function according to P6.8 99 2
PID Controller
P9.1 163
/
rw PID Controller 0 = Deactivated
1 = activated for drive control
2 = activated for external application 100 0
P9.2 118
/
rw PID controllers, P
amplification 0.0 - 1000.0 % 100 100.0
P9.3 119
/
rw PID controller, I reset time 0.00 - 320.00 s 100 10.00
P9.4 167
/
rw PID controller, setpoint
input via operating unit 0.0 - 100.0 % 100 0.0
P9.5 332
/
rw PI controller, setpoint
source 0 = Operating unit (P9.4)
1 = Field bus (option)
2 = AI1
3 = AI2 100 0
P9.6 334
/
rw PID controller, actual value
(PV) 0 = Field bus (Option)
1 = AI1
2 = AI2 100 2
P9.7 336
/
rw PID controller, actual value
limiting, minimum 0.0 - 100.0 % 100 0.0
P9.8 337
/
rw PID controller, actual value
limiting, maximum 0.0 - 100.0 % 101 100.0
P9.9 340
/
rw PID controller, controller
deviation 0 = not inverted
1 = inverted 101 0
P9.10 132
/
rw PID controller, D rate time 0.00 - 10.0 s 101 0.00
P9.11 1431
/
rw PID controller, output filter,
deceleration time 0.00 - 10.0 s 101 0.0
P9.12 1016
/
rw Sleep mode, frequency 0.00 - P6.4 Hz 101 0.00
P9.13 1018
/
rw Sleep mode,
wake up frequency 0.0 - 100.0 % 101 25.0
P9.14 1017
/
rw Sleep mode,
deceleration time 0 - 3600 s 101 30
P9.15 1433
/
rw Hysteresis,
upper limit 0.0 - 100.0 % 101 0.0
P9.16 1434
/
rw Hysteresis,
lower limit 0.0 - 100.0 % 101 0.0
P9.17 1435
/
rw PID controller,
max. system derivation 0.0 - 100.0 % 101 3.0
P9.18 1475
/
rw PID controller,
scale setpoint display 0.1 - 32.7 102 1.0
PNU ID Access right Designation Value range Page FS
(P1.3) User
setting
RUN ro/rw