Continuous Installation
a)
Follow procedures ‘a’ to ‘c’ as per
‘Surface Bracket Installation’.
b)
Install desired fixing method
(recessed, surface or suspended)
and wire.
c)
Fix both leat housings using the
Connector plates
d)
Wire connecting block (see bottom right) from
the incoming Leat and connect to the Leat
previously installed.
e)
Continuous runs over 3m - fit endplates with pre-fitted steel
clip from LEADEKS Kit (to be ordered seperately) one endplate per start and end of run.
Continuous runs up to 3m - Fit LEAEC - One endplate per start and end of run
f)
Fix geartray clamp into the geartray at the start of the run and fix in place. Then fix the next geartray,
locating it in the clamp. Repeat the process for any additional Leats.
g)
Once geartrays have been installed cut and fit diffusers as shown below
5
Wiring
D1
D2
L3
N
L2
L1
LUMINAIRE MUST BE EARTHED
ISOLATE MAINS SUPPLY BEFORE WIRING
Trim Installation
6
RED - Dali (+/-)
WHITE - Dali (+/-)
Unused
BLACK - Live Unswitched
BROWN - Live Switched
GREEN/YELLOW - Earth
BLUE - Neutral
D1 -
D2 -
L3 -
L2 -
L1 -
-
N -
2
NOTE:
Solid core only. Max 2.5mm
First slide the connecting plates into housing,
sitting the bottom of the plate in the small
channel. Fix plate in position with supplied
screw (Do not over tighten). Connect the next
housing onto the plate and secure.
Connector Plates
1
2
RED - Dali (+/-)
WHITE - Dali (+/-)
Unused
BLACK - Live Unswitched
BROWN - Live Switched
GREEN/YELLOW - Earth
BLUE - Neutral
N
1
2
3
+
-
When installing gear
tray ensure pegs (1) on
endplate are engaged into slots (2)
in end of gear tray
Start
End
2 - 3mm
2 - 3mm
Ensure there is
2 - 3mm diffuser
under endplate
Cut end of diffuser
to ensure that 2 - 3mm
can be fitted under
endplate.
Fit diffuser down
length of fitting
Continuous runs over 3m
h)
Continuous runs up to 3m - Fit diffuser into housing. diffuser is pre-cut to
required length, the cut length allows for diffuser expansion.
Start of Run
Cable Entry
Geartray Clamp
Diffuser
4
a)
b)
Follow above instructions but
omitting ‘d)’
Fit end trim from LEADEKR
kit (kit ordered seperatley)
c)
Push trim fully down, drill 2.2mm
dia hole into endplate, using trim
slot as guide. Secure trim to
endplate using screw supplied
with LEADEKR kit
Continuous runs over 3m
Side view
of the trim
fully installed
Housing
Trim
Grub Screw
b
e
c
d
Continuous runs up to 3m
c)
Fit LEAREETK to
endplate by pushing
it into position. No grub
screw needed.
b)
Offer trim up to
the edge of the
Leat housing.
Once located, tighten
grub screws with
a 2mm allen key.
a)
Fit LEAEC one endplate
per start and end of run
d)
Place steel insert on the
endplate
e)
Fold over lazy bend tab
to fix the insert in position.
February 2020
Leat
Instruction Manual - K1121V11
