Page 2
Starting to Set:
1. Go to the keypad and key in your access
code. (Alternatively, if you have a proximity
tag, present your tag to the keypad.)
Either - Full Set:
2.
Press A
.
3. Leave by the designated exit door.
The keypad sounds the exit tone. The dis-
play shows the remaining exit time (in sec-
onds):
Or - Part Set:
2.
Press B (or C or D)
.
3. Leave the area.
The keypad sounds the exit tone. The dis-
play shows the remaining exit time (in sec-
onds):
Completing Setting
At the end of the exit time the warning tone
stops; you should hear a double “beep” confir-
mation tone. The display shows the message
“System Set” for a few seconds. The installer
may also have programmed your external
sounder/strobe to flash briefly.
While the system is set the display shows the
standby screen.
If programmed to do so, the LEDs glow to show
that the system is Full Set (A) or Part Set (B, C
or D).
Unsetting the System:
When unsetting the system do not stray from the
entry route designated by the installer. If you do
so then you will cause an alarm.
1. Enter by the designated entry door or route.
The keypad sounds the entry tone. The sys-
tem starts the entry timer.
2. Go directly to the keypad and either:
Key in your access code
Or
Present your tag to the keypad.
3. The keypad stops the entry tone. The system
is unset.
To Silence the Siren:
1. In the event of an alarm the siren sounds.
2.
If it is safe to enter the premises:
Go to the keypad and EITHER key in your
access code OR present your tag.
A
B
Transmit
LED
Full Set
Part Set
Unset
Not used
Remote
Control
Setting:Full Set
10 to set
Setting:Part Set
10 to set
Press tick to Reset
Burg Z04 Alarm
SETTING FAULTS
Z02 Back door
The siren stops.
The display shows the first zone to alarm.
4. Press
Y
to reset the system.
5. The system returns to standby, and is ready
to set again.
If the System Will Not Set
Normally, the system will set only when all the
detectors are “quiet”, that is: not reporting any
activity. (This does not apply to those detectors
on your exit door or exit/entry route. The system
expects these detectors to be active as you
leave the protected area.)
If you try to set when one or more detectors are
still active then the display shows the words
“SETTING FAULTS” and which zones are active.
You can make the system “omit” those active
zones, either while you are setting the system
(see below) or beforehand (see page 4 for in-
structions on how to omit zones before setting
the system).
1. Follow the instructions in
Starting to Set
.
If any detectors are not yet ready to be set
then the top line of the display shows (for
example):
2. EITHER Press
Y
to carry on setting.
The system sets with the active zones omit-
ted.
OR Stop the setting process by pressing
.
Set by Remote Control
Note: You must program the control unit
to recognise (“learn”) a remote control
or two way fob, see the Administrator’s
Guide.
