System Options Menu
Page 74
when a remote user tries to set the system, the control unit will temporarily ignore the
remote user.
Tamper Omit
If a user omits a zone, it may be necessary also to omit the tamper belonging to that zone.
Enabled
The tamper is omitted when a user omits a zone.
Disabled
The user cannot omit a tamper on a zone.
CSID Code
(Remote Reset)
The purpose of this option is to enable a user in conjunction with the ARC to perform an
Installer reset. Enter any four-digit CSID (Central Station ID) code other than 0000 to
enable the feature. The CSID code is normally supplied by the ARC and identifies the
control unit to the ARC.
When an alarm occurs that requires an Installer reset:
1. A user can silence sounders and sirens in the normal way.
2. When the user attempts to reset the alarm, the control unit prompts the user to call
the ARC and quote a 4-digit number.
3. The user calls the ARC, provides the number and asks for a code to reset the
system.
4. If satisfied with the user's identity, the ARC provides the code to the user.
5. The user enters the code to reset the system.
Silence Alerts
This option controls the length of time that internal sounders give the alert tone (a brief
‘beep’ every second) when there is an alert.
Note:
The control unit will not show alerts while the system is set.
User Code
Internal sounders give the tone until a user keys in an access code to acknowledge
the alert.
30/60/120 minutes
Internal sounders give the alert tone for the selected time. The status LEDs on the
navigation key stay on for the selected time. The alert tone stops if a user enters a
valid access code.
No Alert Tones
Internal sounders give no alert tone. The red LEDs around the navigation key glow to
show that there is an alert.