Setting and Unsetting
Page 16
Unsetting from a one-way remote control
Note:
The ability for remote controls to unset the system can be disabled
(see page 56).
1.
Enter through the entry route designated by the installer.
2.
Depending on how the system is configured, you may hear an entry
tone. If you hear the tone, you will have limited time to unset the
system before it generates an alarm.
3.
Press on your remote control.
Using a one-way i-RK01 radio keypad
A one-way keypad (Figure 4) does not have a display and can only transmit
to the control unit (it cannot receive information back from the control unit).
Figure 4. One-way radio keypad
The keypad cannot show the status of the system. The left-
hand “Transmit”
LED glows only to show that the keypad is sending a command to the
control unit.
Setting from an i-RK01 radio keypad
1.
Make sure the system is in standby.
2.
Enter a valid access code or present your proximity tag to the keypad.
3.
Press (these are the default actions):
A
– To set the system fully (part-setting system) or to set partition 1.
B
– To set part set B (part-setting system) or to set partition 2.
A
B
C
D
1
4 ghi
7 pqrs
*
0
#
2 abc
5 jkl
3 def
6 mno
8 tuv
9 w xyz
“Transmit” LED
Proximity tag
sensor
