![background image](http://html1.mh-extra.com/html/eaton/hfx-series/hfx-series_installation-and-operation-manual_4078136009.webp)
EATON
HFX Product Family Installation and Operation Manual E-ELCL-II002-E2 July 2019
9
2.0
TECHNICAL SPECIFICATIONS
Eaton HFX Controllers
Dimensions
212.61mm L x 134.17mm W x 58.55mm H
Weight
43.2 ounces (1225 grams)
Storage Temperature Range
-40 - +125 °C
Operating Temperature Range
-40 - +105°C (USB use is limited to 85°C)
IP Rating
IP67/IP69K
Operating Altitude
0-4000 m
Supply Voltage
6-32 VDC, Nominal operation @ 12 /24 VDC
Reverse Polarity Protection
Integrated
Peak Supply Voltage
36 VDC
Maximum Current
48 A @ 85°C (40 A @ 105°C)
Idle Current 12/24 VDC
120 mA
Standby Current 12/24 VDC
<3.5mA@12V, <2.5mA@24V
Ignition Pin (A16)
Enable/Disable standby mode
CPU Type
Renesas Super H 72546
Frequency
200 MHz
Bit Width
32 Bit
FPU
Integrated on chip
Data Memory (RAM retain) (additional to cpu)
32 Kbyte
Flash (ROM program & data combined)
3.75 Mbyte
SRAM
256 Kbyte
EEPROM
128 Kbyte
CAN Specification
2.0A, 2.0B
CAN Baud Rates
50 kb/s,100 kb/s,125 kb/s,250 kb/s,500 kb/s,800 kb/s,1Mb/s
CAN Protocol
CANOpen, SAE J1939
CAN CCP Default Node Address
0
CAN Default Baud Rate
250kb/s
USB Specification
USB 2.0 (Note: 3.0 devices are compatible)
USB Baud Rates
See below
USB Default Node Address
N.A.
USB Default Baud Rate
1.5 Mb/s
Number of Sensor Supplies
2
Sensor Supply Output Voltage
5 VDC or 10 VDC (configurable)
Sensor Supply Maximum Current
200 mA @ 5VDC, 100 mA @ 10V per supply
Analog Input Resolution
12 bits, *10 bits
Accuracy
+/- 1 % FS
Measuring Ranges
0...5 V, 0...10 V*, 0...32 V, 0...20 mA
Short Circuit Protection
Integrated
Open Circuit Detection
Dependent upon selectable termination
Input Sampling Frequency
1 kHz
Input Type
Digital Low/High Side (Software configurable)
Maximum Input Frequency
200 Hz
Switch-on Level
Software configurable
Switch-off Level
Software configurable
Input Type
Frequency, Digital Low/High side, (Software configurable)
Maximum Input Frequency Ch 3-8 (FREQ) (0-5 V square wave)
Ch 3-8 0 Hz...50 kHz* in Frequency mode. Note: maximum aggregate is 200 kHz,
Minimum detectable pulse duration is 20 μsec
Maximum Input Frequency Ch 3-8 (Dig)
Switch-on Level (design review required)
Standard switch on at 3.0 V (this can be changed in hardware)
Switch-off Level (design review required)
Standard switch off at 2.0 V (this can be changed in hardware)
HFX Product Family