For more information visit:
www.EatonElectrical.com
Installation
MN05013005E
48
Network cables and plugs
If possible use the prefabricated EZ-NT cables (e.g. 30 or 80
cm).
Other cable lengths can be made using the EZ-NT-CAB cable
and the EZ-NT-RJ45 plug.
AWG 24, 0.2 mm
2
are the largest crimpable cross-sections.
The first and last stations in the network must be provided with
an EZ-NT-R bus termination resistor.
Connecting the power
supply
J
The required connection data for EZD are given in the
Chapter “Technical data”, Page 407.
The EZD devices run a system test for one second after the
power supply has been switched on. Either RUN or STOP
mode will be activated after this time depending on the
default setting.