For more information visit:
www.EatonElectrical.com
EZD Settings
MN05013005E
374
Possible faults
EZD will not start in RUN mode:
• a program is not available in EZD.
• you have selected EZD startup in STOP MODE (RUN
MODE menu).
Card startup behavior
The startup behavior with memory card is for applications
where unskilled personnel change the memory card under no-
voltage conditions.
EZD only starts in the Run mode if a memory card with a valid
program is inserted.
If the program on the memory card is different to the program
in EZD, the program from the card is loaded into EZ and EZ
starts in RUN mode.
X
Switch to the System menu.
Activation of card mode
Requirement: RUN MODE is active.
If EZD displays
CARD MODE
å
, this means that when
the power supply is switched on, EZD will only start in RUN
mode if a memory card with a valid program has been
inserted.
X
Otherwise select
CARD MODE
and press
OK
.
EZD will start up with the program on the card.
X
Press
ESC
to return to the Status display.
J
If EZD is protected by a password, the System menu will not
be available until EZD is “unlocked” (see
“Unlocking EZD” from Page 361).
DEBOUNCE å Æ
P BUTTONS
RUN MODE
å
CARD MODE å
æ