Eaton DF6200, Инструкция по применению

Страница: 30 / 94

30
Amended: April 22
EMEA Fire Technical Support: DF6000/CF3000 Applications Guide
Input Programming General Rules
Function Operational Results Comments
Fire Yes Fire Event on all panels,
local and network This is the default
programming
Fault Yes General fault on all panels,
local and network
Reset Yes Performs a Soft reset on all
panels, local and network
Silence Yes Silences local and
networked panels Will also accept
T1/T2
Technical Input Yes No indication on display,
creates a log entry affects
local and networked panels Active from Jul 17
Provides feedback
for FC6 and smoke
management
Evacuate Yes Sends an Evacuation
command
– overrides most
programming on local and
network
Fire/Extinguisher
Activate N/A German mode only
FRE Activate N/A German Mode only
Non-Fire Yes No indication on display
creates a log entry Local
Panel Only Local devices (loop
card) can be
programmed to
respond to this input,
by address (same
loop) or by specified
zone.
Performance Mode N/A
Cascade N/A
Custom Trigger N/A
FPE Feedback N/A German Mode only
Isolate Addresses Yes No indication on screen
–
will initiate a disablement
Led
– total number of
addresses to isolate from
this address is 8
Non latch function
not required
Isolate Zones Yes No indication on screen
–
will initiate a disablement
Led
– total number of zones
to isolate from this address
is 8
Non-Latch function
not required
Does not work with
zone grouping
Non Latch Yes When the fire condition is
removed the panel local and
network performs a soft
reset Used for interlinking
Day Night Yes When ticked for Day Night
any other device on the
same Loop controller will
follow this signal. When in
night mode a crescent moon
icon appears adjacent to the
top LH corner screen touch
box, no further indication. Devices affected by
this function are
Opto-Thermal smoke
and Heat detectors.
Table 2