Series 9000
SV9IOC105
Page 7
Cutler-Hammer
Document Number: IL.08H.02.T.E
Rev. 01, September 2000
3.2.2
Installation of the SV9IOC105 into a NEMA 1, NEMA 12, or Protected
Chassis Drive
A
Attach the SV9IOC105 board (1) to the
mounting board (8) with the three screws
supplied. Each screw has two nuts
attached. Leave one nut between the
mounting board and the IO board. The
second nut is used to secure the IO board.
Make sure that the installation is stable
B
Remove the keypad by squeezing the two
side tabs and pulling the keypad away from
the drive.
C
Remove the cover of the drive.
D
Detach the panel base from the frame. It is
not necessary to unplug the panel cable
E
Connect the power cable (5) to terminal X5
of the drive’s control board. (The power
cable can also be connected to terminal X6
if terminal X5 is already in use.)