background image

Figure 3

2.  Re-install the back panel and tighten all eight (8) panel mounting screws 

to 80 in-lbs (9.0 N-m).

3.  To make final vertical adjustment, loosen the pivot bolts on the floodlight 

yoke to position floodlight at the desired angle (limited to 60 degrees 

forward and 45 degrees back, as shown in Figure 3).

4.    Rotate the floodlight housing to the desired position.
5.    Tighten the two 1/2”-13 bolts to 45 ft-lbs (61.0 N-m). Tighten the 

5/16”-18 bolts in the adjustment slots to 12 ft-lbs (16.3 N-m).

6.    Turn power on.

MAINTENANCE

• 

Perform visual, electrical, and mechanical inspections on a regular 

basis.  The environment and frequency of use should determine this.  

However, it is recommended that checks be made at least once a 

year.  We recommend an Electrical Preventive Maintenance Program 

as described in the National Fire Protection Association Bulletin NFPA 

70B: Recommended Practice for Electrical Equipment Maintenance 

(www.nfpa.org).  

• 

The lens should be cleaned periodically to ensure continued lighting 

performance.  To clean, wipe the lens with a clean damp cloth.  If this 

is not sufficient, use a mild soap or a liquid cleaner.  Do not use an 

abrasive, strong alkaline, or acid cleaner.  Damage may result.

• 

Visually check for undue heating evidenced by discoloration of 

wires or other components, damaged parts, or leakage evidenced 

by water or corrosion in the interior.  Replace all worn, damaged, or 

malfunctioning components and clean gasket seals before putting the 

luminaire back into service. 

• 

Electrically check to make sure that all connections are clean and 

tight.

• 

Mechanically check that all parts are properly assembled.

REPLACEMENT PARTS

Eaton’s Crouse-Hinds series Pro-Flood LED Floodlights are designed 

to provide years of reliable lighting performance.  However, should 

the need for replacement parts arise, they are available through your 

authorized Crouse-Hinds distributor.  Assistance may also be obtained 

through your local Crouse-Hinds representative or the Crouse-Hinds Sales 

Service Department, P.O. Box 4999, Syracuse, New York 13221, Phone 

866-764-5454.

DIMENSIONS

532.9

21.0

405.9

16.0

525.6

20.7

203.7

8.0

277

10.9

234.5

9.2

552.5

21.75

.55

120.7

4.75

IF 1684  •  04/22 

                      Copyright © 2022, Eaton’s Crouse-Hinds Division                                                                       Page 2

Figure 4

60°

45°

105°

45°  PAST

VERTICAL

60°  BEFORE

VERTICAL

AIMING RANGE

Units: (mm)
           inches

Отзывы: