60
General Information
Preventive Maintenance Overview
To ensure long life and proper operation of the release mecha-
nism of the clutch, it is important to properly lubricate the fol-
lowing areas.
Lubrication
1.
Release Bearing - The cast iron bearing housing will
be equipped with either a standard grease fitting or a
lube tube extension. If a lube tube is not present, it is
necessary to remove the inspection cover to gain
access to the grease fitting. Apply grease until it
purges from the rear of the housing. Grease on the
clutch brake friction surface and the transmission
input shaft will extend the life of the clutch brake and
bronze bushings inside the release sleeve.
2.
Release Bearing Wear Pads - Where the release
fork contacts the bearing housing, there are small
hardened steel pads. Apply a small amount of grease
to the wear pads where the clutch release fork con-
tacts.
3.
Clutch Brake - The clutch brake friction material is
designed to operate with lubricant. While lubricating
the release bearing, grease should purge from the
housing and contact the clutch brake. This is benefi-
cial for long clutch brake life. If desired, a small
amount of grease could be applied to both sides of
the clutch brake.
4.
Cross-Shaft Bushings - Lubricate both the left and
the right cross-shaft bushings per OEM recommen-
dations.
5.
Clutch Control Linkage - Lubricate the clutch linkage
bell cranks and pivot pins per OEM recommenda-
tions.
6.
Pilot Bearing - The pilot bearing inside the flywheel
is a sealed for life bearing and requires no lubrica-
tion. Use a premium pilot bearing to prevent clutch
drag and early bearing failures. (C-3, C-4, C-5 Suffix)
Lube Tube Assembly
The Eaton Lube Tube Assembly enables the release bearings
in Eaton medium and heavy duty clutches to be greased with-
out removing the bell housing inspection cover. The Lube
Tube Hose replaces the original zerk fitting on the release
bearing and protrudes through the bell housing window.
Lube Tube Lengths
Lube Hose Kits/Assemblies for Hydraulic Release
System
Recommended Lubrication
Incorrect grease and improper lube procedures will cause
bearing failures, bushing wearout, yoke tip and bearing wear
pad wear.
For a list of recommended lubricants, see TCMT-0020 or call
1-800-826-HELP (4357).
Lubrication Interval
The DM UltraShift clutch does not require any lubrication or
adjustment. There is no clutch linkage associated with this
product, therefore there is no linkage adjustment or mainte-
nance requirements.
For recommended lubrication intervals, see TCMT-0021 or
call 1-800-826-HELP (4357).
Length in Inches
Part Number
12"
CLT012
9"
CLT009
8"
CLT008
7"
CLT007
6"
CLT006
Kit/Assembly
Description
K-4050
Used with Solo Advantage
clutches
A-7857
Used with Non-Solo
Advantage
TM
clutches
CAUTION
Содержание CLSM0200
Страница 2: ......
Страница 4: ...ii Warnings ...
Страница 6: ...iv Table of Contents ...
Страница 67: ......