Eaton Char-Lynn 2000 Series, Информация по ремонту

Страница: 4 / 12

4
2000 Series Disc Valve Motors
Outer Face Seal
Inner
Face Seal
Pin (2) and
Spring (2)
Valve Balance Ring
Seal
Valve Drive
Valve Plate
Seal
Seal Geroler
Bearing
Housing Seal
Shaft Face Seal
Wear
Plate
Bearing Housing Shaft Seal
Back-up Washer
Exclusion
Seal
7 Remove balance ring assembly.
8 Remove inner and outer face seals from balance ring.
9 Remove the valve.
10 Remove the valve plate.
11 Remove the 76,0 [3.00] diameter seal from valve plate.
12 Remove the valve drive.
13 Remove the Geroler. Be sure to retain the rollers in the outer ring
if they are loose.
14 Remove the drive.
15 Remove the 76,0 [3.00] diameter seal from wear plate,
see Figure 7.
16 Remove the wear plate.
17 Remove the shaft face seal from the wear plate.
18 Remove the 76,0 [3.00] diameter seal from bearing housing.
19 You may need a press to remove shaft and bearing assembly from
bearing housing. (Key must be removed before removing shaft.)
20 Use a small screwdriver to remove shaft seal, back-up washer and
exclusion seal from bearing housing, see Figure 10. Do not damage
bore of housing.
Note: Individual parts of shaft and bearing assembly are not sold
separately. Replace as a unit.
Figure 5
Figure 6
Figure 7
Figure 10
Figure 9
Figure 8
Disassembly
Bearing
Housing
Shaft and
Bearing
Assembly