Installation & User Guide
Effective January 2020
INSTALLATION INSTRUCTIONS
25-12407-G January 2020
Eaton
EMEA Headquarters
Route de la Longeraie 7
1110 Morges, Switzerland
Eaton.eu
TEL: +44 (0) 1302 321541
FAX: +44 (0) 1302 303220
© 2020 Eaton
All Rights Reserved
Eaton is a registered trademark.
All trademarks are property
of their respective owners.
www.Eaton.com
Eaton Electrical Systems Ltd.
Wheatley Hall Road
Doncaster
DN2 4NB
TEL: +44 (0) 1302 303303
FAX: +44 (0) 1302 367155
(i) Knock-Out the required fixing holes
(ii) Fix to mounting surface using
two suitable screws
If the base deforms on an uneven
surface, loosen the screws or move
to a more flat position.
(i) Clip Sounder onto base
If sounder needs to be removed
use a small screwdriver to unclip
Do not bring excessive cable into
the sounder/beacon as this can
interfere with the fitting of the
detector, keep cable tails to
a minimum.
Fit the locking tab into the square hole
on the sounder.
Finish assembly as stage 5.
Remove by inserting a
suitable tool (eg screwdriver)
into the hole in the detector /
cover, the rotate detector /
cover anti-clockwise.
WARNING Do NOT use high
voltage testers if ANY equipment
is connected to the system.
Earth screen must be continuous
along entire length of loop.
Locking tab
release hole
1.67
