2
Carrel Organizer
EATON
www.eaton.com
Technical Data
Instruction Sheet
IL211005EN
Effective May 2018
Figure 2
Drill template
Corner of worksurface
Perforations
Figure 3
Worksurface
#10 x 3/4” Phillips
pan head screws
Mounting bracket
Previously drilled
holes
Mounting bracket
Weldnut
Fastening the organizer to a LINX worksurface
1. Using the cardboard Drill Template provided, drill
two
1
/
8
" diameter holes approximately
1
/
2
" deep into
the two corners of the Linx Corner Workstation as
shown in figure 2.
Carefully fold the template along perforations and
place the template on the corner of the worksur-
face as shown in figure 2.
Fold the tab on the opposite end of the template
for the other corner of the worksurface.
2. Position a
Mounting Bracket
at each corner of the
worksurface, carefully noting the location of the
weldnuts. Install four #10 x
3
/
4
" Phillips pan head
screws provided into the previously drilled holes.
See figure 3.
3. Using the Mounting Brackets as templates, drill
four more
1
/
8
" diameter holes approximately
1
/
2
" deep into the worksurface and install the
remaining screws.
Figure 2
Figure 3
89072 2
