Effective April 2018
Supersedes 89072
Instruction Sheet
IL211005EN
Carrel Organizer
Tools Required
•
Phillips head screwdriver
•
5
⁄
32
" Allen wrench (provided)
•
Electric drill
•
1
⁄
8
" Drill bit
•
Drill template (provided)
IMPORTANT:
It is recommended that the
assembly of this product be done on the floor.
Assistance may be required
Assembling the Organizer
1.
Phillips 1. Carefully slide the
Uprights
over the
ends of the
Back Panel
. Be sure that the holes
for Mounting Brackets are at the bottom of the
Uprights. See figure 1.
2. Install the
1
/
4
"-20 x 2
1
/
2
" Button
head cap screwsthrough the
Uprights and through the Back
Panel. Thread the screws in until
their heads touch the Uprights
(snug fit).
DO NOT TIGHTEN
.
See figure 1.
3. Make sure that the bottom of the
Back Panel and Uprights are flush.
Starting at the bottom, tighten each
screw 1/4 turn from the snug position.
DO NOT OVER TIGHTEN.
Carrel Organizer
Figure 1
Back panel
Arrow label “Install
this side up”
Upright
1/4”-2- x 2-1/2” Button
head cap screws
Holes for Mounting
brackets
Carrel Organizer
Figure 1
Back panel
Arrow label “Install
this side up”
Upright
1/4”-2- x 2-1/2” Button
head cap screws
Holes for Mounting
brackets
Figure 1
