© 2021 Eaton
All Rights Reserved
Printed in USA
Document No.: E-HOAS-TT008-E
Eaton
Hydraulics Group USA
14615 Lone Oak Road
Eden Prairie, MN 55344
USA
Tel: 952-937-9800
Fax: 952-294-7722
www.eaton.com/hydraulics
Assembly Instructions:
Step 1
- Insert the two knobs into the feet of the CB-63X
cabinet base from the bottom as shown in
Figure A.
Step 2
- Stand the CB-63X cabinet base up on its side
as shown in
Figure B
.
Step 3
- Lay the C-15X fifteen drawer cabinet on its side
positioned against the CB-63X cabinet base as shown
in
Figure C
. Remove the bottom left and bottom right
drawers as show in
Figure D
.
Step 4
- Make sure the bolt holes in the base and
the cabinet are aligned. Secure the C-15X cabinet
to the CB-63X base using the (4) 60mm length bolts,
(8) washers, and (4) wing nuts as shown in
Figure E
.
Do not fully tighten them yet.
Step 5
- Stand the assembly back up on the feet of the
CB-63X cabinet base. Make any adjustments necessary
to ensure the C-15X cabinet is even on the CB-63X base
and then tighten the bolts. Adjust the plastic knobs on the
front of the CB-63X base so that the cabinet assembly
is level or has a slight backwards lean to prevent it from
falling forward and to keep the drawers from sliding out.
Place the C-15X drawers that were removed back in the
cabinet. See
Figure F
.
Step 6
– Place the first C-63X sixty-three drawer cabinet
on top of the C-15X cabinet. Remove the top left and top
right drawers from the C-15X cabinet. Next, remove the
drawers from the bottom left and bottom right of
the C-63X cabinet as shown in
Figure G
.
Step 7
- Make sure the bolt holes in both cabinets are
aligned. Secure the first C-63X cabinet to the top of
the C-15X cabinet using the (4) 45mm length bolts, (8)
washers, and (4) wing nuts as shown in
Figure H
.
Step 8
- Repeat step 7 to secure the second C-63X cabinet
to the top of the first C-63X cabinet using (4) 45mm length
bolts, (8) washers, and (4) wing nuts. Insert the black
drawer dividers into the slots in the drawers to separate
the drawers into sections as desired. Replace any drawers
that were removed to complete the cabinet assembly.
Figure A
Figure F
Figure G
Figure H
Repeat H
Complete
Figure B
Figure C
Figure D
Figure E
